Tillman GM EN-49248 6706 Injector Rail Remover

Description

Tillman GM EN-49248 6706 Injector Rail Remover

Similar to EN-49248 and compatible with OTC 6706.

Used to properly remove the direct injection fuel rail without damage to the injectors, cylinder head, and rail mount assemblies. In place of the mounting bolts, helps safely reach under the injector rail near each mount location.

The fuel rail and injector assembly used on the Hitachi SIDI system on 2010 LF1 3.6L V6 and LAF 2.0L ECOTEC has two seals on each injector, and these seals are installed with very tight tolerances. Once the engine has been run, injector and rail removal is very difficult, and the assembly must be removed as straight as possible to prevent the chance of damaging an injector bore in the cylinder head, or to the mount assembly.

Each mount assembly contains an isolator, and cannot have any force applied to the mount for removal. EN-49248 installs in place of the mounting bolts, and reaches under the injector rail near each mount location. The hand wheels on EN-49248 at each mount location are tightened evenly to un-seat all injectors evenly, preventing damage to the injectors, cylinder head, and rail mount assemblies.

Note: If you are working on a 5.3L or 6.2L you will need a quantity of 2 sets.